Attaching The Control Panel - DURKOPP ADLER 281 Operating Manual

62

7.12 Attaching the control panel

Figure 40: Attaching the control panel
①
(1) - Cable holder
(2) - Control panel
(3) - Control panel bracket
(4) - Fastening screws
1. Loosen the fastening screws (4).
2. Remove the control panel bracket (3).
3. Screw the control panel (2) onto the control panel bracket (3).
4. Screw the control panel bracket (3) firmly onto the machine
arm again using the fastening screws (4).
5. Screw the connecting cable for the control panel firmly onto
the machine arm using the cable holder (1).
6. Loosen all three handwheel screws (5).
7. Loosen all four handwheel cover screws (6).
8. Remove the handwheel cover (7).
9. Install the connecting cable for the control panel tidily
underneath the handwheel cover and guide it downwards
through the table plate cut-out.
10. Fit the handwheel cover (7).
11. Tighten all three handwheel screws (5).
12. Tighten all four handwheel cover screws (6).
② ③
④
(5) - Handwheel screws
(6) - Handwheel cover screws
(7) - Handwheel cover
Operating manual 281 Version 06.0 - 05/2013
Set-up
⑤
⑥
⑦
⑥