Getting Ready To Sew; Connecting Machine To Power Supply; For Your Safety; Operating Instructions - Kenmore 385.16528000 Owner's Manual

SECTION I1. GETTING READY TO SEW
Connecting
Machine to Power
Supply
Power supply plug
(_) Power switch
Outlet
(_) Machine socket
@ Machine plug
(_ Light bulb
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
1. Turn off the power switch (_.
2. Insert the machine plug (_ into the machine socket (_.
3. Insert the power supply plug _ into the outlet _.
4. Turn the power switch (_)to turn on the power and
sewing light _}.
For Your
Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Operating
Instructions:
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fully in the outlet, reverse the plug. If it still does
not fit, contact a qualified electrician to install the proper
outlet. Do not modify the plug in any way.
Foot Controller Model YC-482J -1 or TJ C-150 is used with
Sewing Machine Model 385.16528XXX.
XXX - represents numbers 000 through 999.
Controlling Sewing Speed
Sewing speed can be varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
S
f-
f-
J
/
J