Getting Ready To Sew; Connecting Machine To Power Supply; Before Using Your Sewing Machine; For Your Safety - Kenmore 385.19112 Owner's Manual

SECTION II. GETTING READY TO SEW
Connecting Machine to Power Supply
_i} Power switch
_2} Machine plug
_3_Machine socket
_4} Power supply plug
_5_Wall outlet
Before connecting the power cord, make sure the voltage
and frequency shown on the machine conform to your
electrical power.
Ii_ Turn the power switch off _i}.
[2J Insert the machine plug _2}into the machine socket _3}.
I_ Insert the power supply plug _4}into the wall outlet _5}.
[4] Turn the power switch on _i_.
ON ON
OFF OFF ",
@
Before Using Your Sewing Machine
Before using your sewing machine for the first time, place a
waste fabric under the presser foot and run the machine
with thread for a few minutes. Wipe away any oil which may
appear.
For Your Safety
* While in operation, always keep your eyes on the sewing
area. Do not touch any moving parts such as the thread
take-up lever, handwheel or needle.
* Always turn off the power switch and unplug from the
power supply:
- When leaving the machine unattended.
- When attaching or removing any parts.
- When cleaning the machine.
* Do not place anything on the foot control, when not
sewing.
Polarized Plug
This appliance has a polarized plug (one blade wider than
the other). To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. If the plug
does not fit in the outlet, reverse the plug. If it still does not
fit, contact a qualified electrician to install the proper outlet.
Do not modify the plug in any way.
Foot Controller Model YC-482J-EC or TJC-150 is used with
Sewing Machine Model 385.19112.
Controlling Sewing Speed
Sewing speed is varied by the foot control.
The harder you press on the foot control, the faster the
machine runs.
s -x
/
f
J