Kenmore 385.16528000 Owner's Manual page 86

(_ Mark for placement of buttonhole
_) Starting point
@ Slider
There should be no gap.
_t_Spring holder
(_ Difference
[] Draw both threads to the left under the foot.
Insert the garment under the foot, and lower the needle
at the starting point.
Then lower the automatic buttonhole foot.
Make sure there is no gap _)between the slider@and
the spring hotder(_. If there is a gap@, the length
of the rows will be different, as shown in _.
Sew slowly and stop the machine at the starting point
when a buttonhole is completed.
[] Remove the fabric and place a pin just before the
bartack at each end to prevent cutting bartacks. Cut the
opening with the buttonhole opener.
[] After a buttonhole is sewn, move the stitch to the next
stitch by turning the stitch selector in direction of_)or_6),
then return the stitch back to" _] "to reset for sewing the
next buttonhole.
[] When finished, push the buttonhole lever up as far as it
will go.
S
[]
s
[]
f-
[]
s
/
/
/
J
Y
\
J
J
78