Mode 2 (Exchange Line Setting - Panasonic VB-9411ADSUK Operation Instructions Manual

MODE 2 (Exchange Line Setting)

(01-04)01#-(0 or 1)#
DIAL SIGNAL / EXCHANGE LINE
The dial signal type you select must be in accordance
with the type of PBX or local telephone service pro-
vider.
0#: 10 pps pulse dial
1#: DTMF signal tone
(01-04)02#-(0, 1 or 2)#
DTMF SIGNAL SENDING TIME
To set the length of the signal and the pause for Ex-
change line.
0#: 80 mseconds ON/80 mseconds
OFF(Signal length/Pause length)
1#: 125 mseconds ON/125 mseconds OFF
2#: 250 mseconds ON/250 mseconds OFF
(01-04)03#-(0 or 1)#
CONNECTED PHONE LINE
To connect Exchange lines or PBX lines.
0#: Exchange line
1#: PBX line
(01-04)04#-(0 or 1)#
(AUTO) PAUSE PBX LINE
Inserts a pause after dialing. When accessing a trunk
line through a PBX, it can take several seconds from the
time the line is accessed to when it a trunk line.
If a pause is not inserted after dialing, connection to the
trunk line may not be possible.
0#: No automatic pause
1#: Automatic pause
REFERENCE : See MODE 1 0210# to 0219#.
(01-04: Exchange
c
line No.)
(01-04:Exchange c
line No.)
(01-04: Exchange c
line No.)
(01-04: Exchange
c
line No.)
P-37
PROGRAMMING (MODE 2)
(01-04)05#-(0, 1-3)#
POOLED TRUNK ACCESS GROUP (9/0,
811, 812, and 813)
When 9/0, 811,812, or 813 is dialed there is an auto-
matic connection to a vacant line in the trunk groups.
0#: Pooled trunk access group 9/0
1#: Pooled trunk access group 811
2#: Pooled trunk access group 812
3#: Pooled trunk access group 813
NOTE : • Using Dial 9 or using Dial 0 will be determined
by Operator Call Dial Setting [MODE 1 0411#].
• Two or more settings can be assigened.
• To delete the input data, press the same data
number (0-3) again.
• The LINE key has the same function as group 9/0.
(01-04)06#-(0, 1-8)#
INCOMING RING TONE PATTERN
The ring tone pattern can be changed for each Exchange
line port. The incoming ring interval is synchronized by
your telephone service provider.
This function allows you to set different ring patterns
for each Exchange line in the system. Lines with this
setting have their own distinctive ring pattern, which
makes it easier to identify which line is ringing.
1sec 2sec 3sec
0#: Synchronized
1#:
2#:
3#:
4#:
5#:
6#:
7#:
8#:
(01-04: Exchange
cM
line No.)
(01-04: Exchange
c
line No.)
4sec 5sec 6sec