When you use as 2-Line telephone;
Connect one line to
and the other line to
When you use as single cine telephone;
and set the Selector lo
Otherwise the Line Indicator on line
will stay lit continuously
and consume banety power.
Selection of Line Mode Selectors
"B" position is for PBX system (Low Volt).
If the line indicator remains on when you connect the
unit to the telephone line and place the handset in
the crddle (on-hook condition), switch the selector
If the line indicator does not light when lifting the
handset of another telephone connected on the
same line, confirm whether the selector is set to "A"
it is set to "B", switch to "A".
Select the proper position on each line.
When using two telephone lines, avoid combining a normal telephone line and
a low voltage line such as a PBX system.
Connection to two normal telephone lines is
Connection to two low voltage lines such as a PBX system is
Connect one line to a normal telephone line and the other line to a low voltage
line such as a PBX system should be avoided.