Doorphone/Doorlatch I/F Card; Connecting The Doorphone - Panasonic VB-9411ADSUK Operation Instructions Manual

CONNECTION OF OPTIONAL UNITS

DOORPHONE/DOORLATCH I/F CARD

Doorphone/Doorlatch I/F Card Specifications
Item
Doorphone Number of connected units
Loop resistance
Ringing tone
Door opener Number of outputs
(relay)
Contact capacity
Modes
Sensor Type
Detection time
Ringing tone
Others Power supply
Current consumption
Installing the Doorphone/Doorlatch I/F Card
WARNING
Always unplug the AC plug from the outlet and power off the switch (STD BY) of the CCU
when mounting the Doorphone/Doorlatch I/F card.
q Align the Doorphone/Doorlatch I/F Card with the installation groove on the CCU, and insert
until the Doorphone/Doorlatch I/F Card is locked by the claws on the CCU.
w Insert the connector from the Doorphone/Doorlatch I/F Card into CN4 on the CCU.

Connecting the Doorphone

Two Doorphones can be connected by using a DDK connector.
q Connect Doorphone A to pin Nos.1 and 2 of the DDK connector, and Doorphone B to pin Nos.
3 and 4.
w Connect the DDK connector to CN2 on the Doorphone I/F Card.
e Attach the EMI filter to the cable.
Connecting the Sensor
A Sensor can be connected by using a DDK connector.
q Short-circuit the pins Nos.1 and 2 of the DDK connector.
w Connect Sensor+ to pin No.3 of the DDK connector and Sensor- to pin No.4.
e Connect the DDK connector to CN4 on the Doorphone/Doorlatch I/F Card.
Connecting the Door Opener
Up to two Door Openers can be connected.
q Connect the leads from Door Opener A to the C (Common) and M (Make) terminals of CN3
Door Opener-A on the Doorphone/Doorlatch I/F Card.
w In the same way, connect the leads from Door Opener B to the C (Common) and M (Make)
terminals of CN3 Door Opener-B on the Doorphone/Doorlatch I/F Card. Put the cables to-
gether into the cable clamp.
NOTE : • When connecting the leads to the terminals of CN3 on the Doorphone/Doorlatch I/F Card, press the connector
knob using a screwdriver to insert the lead. Return the connector knob to secure the lead in place.
• Method or time of control can be set using Program. (See MODE 1 System 0502# to 0505# of Programming
Manual.)
Table 4. Specifications
2
20 Ohms
2 Types (Chime, tremolo)
2
Max. DC 24V, 1A
3 Modes (Door opener, multi, ringer)
Non-voltage
250m Seconds, MIN (10mA)
Siren (settable)
24V Supplied from CCU
20mA
I-22
Description