Zero Point Adjustment; Tare Adjustment - A&D SF-6KB Instruction Manual

SF/SG Series Operating Instructions

1. Zero Point Adjustment

The zero point is automatically adjusted when power is turned on. If the display shows a positive or
negative weight, the scale must be re-zeroed.
How to re-zero:
Step 1: Assure that nothing is on the weighing pan.
Step 2: Press
Step 3: The WEIGHT display should read:
NET
ZERO

2. Tare Adjustment

When weighing with a container, it is necessary to TARE out the weight of the container in order to
get an accurate price/weight reading.
How to operate TARE:
Step 1: Place an empty container (e.g., 100 g) on the weighing pan. The display reads
Step 2: Press
Step 3: The WEIGHT display should read:
NET
ZERO
Step 4: When removing the container from the pan, the display reads
Note:
When a TARE weight has been set, it is not possible to set a new TARE weight of
a lower value by the procedures above. It is necessary to delete the previous TARE
first, before entering a TARE of lower value.
0
.
ZERO
SG series
0.000
T
.
TARE
SG series
0.000
SF series
0.000
NET ZERO
100
"
SF series
0.000
NET ZERO
-100
" ".
".
5