Hp E1368A/69A/70A Error Messages - HP E1368A/69A/70A User Manual

HP E1368A/69A/70A Error Messages

No. Title
-211 Trigger ignored
-213 INIT ignored
-224 Illegal parameter value
1500 External trigger source
already allocated
2000 Invalid card number
2001 Invalid channel number
2006 Command not supported
on this card
2008 Scan list not initialized
2009 Too many channels in
channel list
2010 Scan mode not supported
on this card
2012 Invalid Channel Range
2600 Function not supported on
this card
2601 Channel list required
Appendix C
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table C-1 lists the error messages associated with the Microwave Switch
module programmed by SCPI. See the appropriate mainframe manual for a
complete list of error messages.
Table C-1. Microwave Switch Error Messages
Trigger received when scan not enabled. Trigger received after scan
complete. Trigger too fast.
Attempted to execute an INIT command when a scan is already in
progress.
Attempting to execute a command with a parameter not applicable to
the command.
Assigning an external trigger source to a switchbox when the trigger
source has already been assigned to another switchbox.
Addressing a module (card) in a switchbox that is not part of the
switchbox.
Attempting to address a channel of module in a switchbox that is not
supported by the module (e.g., channel 99 of a multiplexer module).
Sending a command to a module (card) in a switchbox that is
unsupported by the module.
Executing a scan without the INIT command.
Attempting to address more channels than available in the switchbox.
Sending a command to a module (card) in a switchbox that is
unsupported by the module
Invalid channel(s) specified in SCAN <
Attempting to begin scanning when no valid channel list is defined.
Sending a command to a module (card) in a switchbox that is not
supported by the module or switchbox.
Sending a command requiring a channel list without the channel list.
Potential Cause(s)
channel_list
HP E1368A/69A/70A Error Messages 79
Appendix C
> command.