Scpi Command Reference; Abort - HP E1368A/69A/70A User Manual

SCPI Command Reference

ABORt

Subsystem Syntax
Comments
Example
50 HP E1368A/69A/70A Command Reference
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
This section describes the Standard Commands for Programmable
Instruments (SCPI) commands for the Microwave Switch modules.
Commands are listed alphabetically by subsystem and also within each
subsystem.
The ABORt subsystem stops a scan in progress when the scan is enabled via
the interface, and the trigger modes are
TRIGger:SOURce HOLD .
ABORt
Operation invalidates the current channel list and sets
ABORt
(one scanning cycle per
ARM:COUNt 1
INITiate CONTinuous OFF
TRIGger:SOURce IMMediate
Stopping Scans Enabled from Interface: When a scan is enabled
from the interface, use an interface
E1301 front panel "Reset Instr" or "Clear Instr" key to stop the scan.
When the scan is enabled from the interface and the trigger source is
TRIGger:SOURce BUS
the HP E1301 front panel "Reset Instr" or "Clear Instr" keys to stop
the scan.
Stopping Scans Enabled from Front Panel: When a scan is
enabled from the HP E1301 front panel, execute
interface or the front panel "Reset Instr" or "Clear Instr" keys to stop
the scan.
Related Commands:
TRIGger
Stopping a Scan with ABORt
This example stops a (continuous) scan in progress.
TRIG:SOUR BUS
INIT:CONT ON
SCAN (@100:102)
INIT
ABOR
TRIGger:SOURce BUS
command), sets
INITiate
(no continuous scanning cycles), and sets
(continuous internal triggering).
CLEAR command or the HP
or
TRIGger:SOURce HOLD
,
ARM INITiate:CONTinuous
BUS is trigger source.
Set continuous scanning.
Scan channels 00-02.
Starts scanning cycle, close
channel 00.
Aborts scan in progress.
or
, use or
ABORt
over the
*RST
, ,
[ROUTe:]SCAN
Chapter 4