Arm; Count - HP E1368A/69A/70A User Manual

ARM

:COUNt

Parameters
Comments
Example
Chapter 4
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
The ARM subsystem selects the number of scanning cycles (1 through
32767) for each INITiate command.
ARM
number > MIN | MAX
:COUNt <
:COUNt? [MIN | MAX]
ARM:COUNt < number > MIN | MAX
multiple of times (1 to 32767) with one
INITiate:CONTinuous OFF | 0
cycles.
Parameter Name Parameter Type
number
numeric
Number of Scans: Use only numeric values between 1 and 32767
for the number of scanning cycles (default is 1).
Related Commands:
*RST Condition:
Setting Ten Scanning Cycles
This example sets a Microwave Switch for 10 scans of channels 00 through
02. When the scan sequence completes, channels 00 through 02 (switches
00 through 02) are closed.
ARM:COUN 10
SCAN (@100:102)
INIT
HP E1368A/69A/70A Command Reference 51
allows scanning cycles to occur a
INITiate command when
is set. MIN sets 1 cycle and
Range of Values
1 - 32767 | MIN | MAX
,
ABORt INITiate:IMMediate
ARM:COUNt 1
Set 10 scans per INIT command.
Scan channels 00-02.
Start scan, close channel 00.
MAX sets 32,767
Default Value
1