Cisco Mgx 8220 Management - Cisco MGX 8220 Installation And Configuration Manual

Chapter

Cisco MGX 8220 Management

The functions and operation of the Cisco MGX 8220 shelf are achieved through downloaded firmware.
The firmware controls the overall operation of the shelf and responds to configuration commands.
The current status and configuration parameters of the Cisco MGX 8220 modules are maintained in a
Management Information Base (MIB). The firmware updates the MIB when changes in status and
configuration occur. The MIB can be interrogated using SNMP commands.
Most functions of the Cisco MGX 8220 shelf Release 5.0 can be accessed through the graphical user
interface (GUI) of the Cisco WAN Manager (CWM), Release 9.2. CWM is a network and element
management system that enables operations, administration, and maintenance of WAN-multiservice
networks.
CWM was formerly known as StrataView Plus.
Note
The Cisco MGX 8220 supports the following user interfaces:
•
•
•
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
The ASC module includes three ports for user input of management commands. Another means of
management access is provided in-band over the ATM trunk.
The maintenance port is a simple RS-232 port for direct connection to an alpha-numeric terminal
into which you can type commands through a command-line interface (CLI).
The control port (SLIP protocol only), the LAN (Ethernet) port and the in-band ATM connection
all support the CLI (using Telnet), TFTP, and SNMP protocols for communicating with the Cisco
MGX 8220 shelf.
Cisco MGX 8220 System Overview
Cisco MGX 8220 Installation and Configuration
1-9