Table of Contents
Advertisement
Chapter
Provisioning FRSM Channels
To provision a FRSM channel in a stand-alone application:
1.
2.
3.
4.
Provisioning AUSM Channels
To provision a AUSM channel in a stand-alone application
1.
2.
3.
Release 5.0, Part Number 78-6430-03 Rev. D0, November 2003
Enter the cc command to change the active CLI card to the slot number corresponding to the
channel to be provisioned. For example,
myshelf.1.3.ASC. a >
5
cc
Enter the addln command to add a physical line (line number corresponds to the physical line
module port number for the channel being provisioned). Then enter the dsplns command to verify
the line has been added. For example,
myshelf.1.5.FRSM. a >
addln
myself.1.5.FRSM. a >
dsplns
Enter the addport command to add a Frame Relay port to the enabled line. Then enter the dspports
command to verify the port has been added. For example,
myshelf.1.5.FRSM. a >
addport
myself.1.5.FRSM. a >
dspports
Enter the addchan command to add a Frame Relay endpoint. Then enter the dspchans command
to verify the channel has been added. For example,
myshelf.1.5.FRSM.a>a
ddchan
myself.1.5.FRSM.a>
dspchans
Enter the cc command to change the active CLI card to the slot number corresponding to the
channel to be provisioned. For example,
myshelf.1.3.ASC. a >
5
cc
Enter the addln command to add a physical line (line number corresponds to the physical line
module port number for the channel being provisioned). Then enter the dsplns command to verify
the line has been added. For example,
myshelf.1.5.AUSM. a >
addln
myself.1.5.AUSM. a >
dsplns
Enter the addport command to add a ATM port to the enabled line. Then enter the dspports
command to verify that the port has been added. For example,
myshelf.1.5.AUSM. a >
addport
myself.1.5.AUSM. a >
dspports
(add line parameters)
Cisco MGX 8220 Installation and Configuration
Provisioning FRSM Channels
6-5
Advertisement
Table of Contents
Troubleshooting
