Cycle Status Indicators - Kenmore 665.15972 Use & Care Manual

Delay
Houm
Select this option to run your dishwasher at a later time or
during off-peak hours.
To delay the start
1. Close the door.
2. Select a wash cycle and options.
3. Press DELAY HOURS 1 time for a 2-hour delay, 2 times
for a 4-hour delay, or 3 times for a 6-hour delay.
Houns
2 4 6
@
The number glows above Delay Hours. The dishwasher
starts the cycle in the selected number of hours.
4. Press START.
NOTE: To cancel the delay, press DELAY HOURS until all
Delay Hours lights are off.
IMPORTANT:
• Operate your dishwasher only when you are at home.
• If your home is equipped with a water softener, do not
start the dishwasher during the regeneration of the
softener.
CycleStatusIndicators
Follow the progress of your dishwasher with the Cycle
Status Indicators. CLEAN glows when a cycle is finished.
The light turns off when you open the door or press
Cancel/Drain.
Ft_W_ _ IWt If*fJ_ M WM_ WmmI/r_nu Rmt41m _ IMm _K_t_E
Favorite Cycle Sat
FAVORITE CYCLE SET glows when your favorite cycle
selections are saved. If the power is off, or if the door is left
open for an extended period of time, the Favorite Cycle
memory defaults to Normal Wash and No Heat Dry. The
light goes off.
Sensing
Your dishwasher senses the soil level on the dishes. Soil
level determines the length of some cycles, the amount of
heat added to the wash or rinse, and the cycle needed for
the load. SENSING glows during the soil sensing parts of
the cycle. Wash action continues while sensing occurs.
Washing
WASHING glows while your dishes are washed.
Water Heating
WATER HEATING glows, and the cycle progression
pauses, whenever water is heated during a cycle. Wash or
rinse action continues as the water heats.
Rinsing
RINSING glows while your dishes are rinsed.
Drying
DRYING glows while your dishes are drying.
Sani
Complete
If you select the Sani Rinse option, SANI COMPLETE
glows when the Sani Rinse cycle is finished. If your
dishwasher did not properly sanitize your dishes, the light
flashes at the end of the cycle. This can happen if the cycle
is interrupted. The light goes off when you open the door.
Clean
CLEAN glows when a cycle is finished. The light turns off
when you open the door, press Cancel/Drain, or press
another cycle or option.
Lock On
When LOCK ON is lit, all buttons are disabled.
O
LOCKON
You can turn on the Lock while the dishwasher is running.
To lock or unlock the controls, see "Option Selections."
Rinse Aid Empty
Fill the Rinse Aid dispenser when RINSE AID EMPTY is tit.
Rinse aids prevent water from forming droplets that can
dry as spots or streaks.
RINSE A IDEMPTY
If the Rinse Aid dispenser is empty, the light glows when
you select a cycle or while a cycle is running.
18