Fujitsu Scan Snap S1300i Operator's Manual page 449

5.
Clean the feed roller and the eject roller with a cloth moistened with
Cleaner F1.
ATTENTION
Do not use water or mild detergent to clean the inside of the ScanSnap.
It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth
with moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
Eject roller (×2)
Feed roller (× 2)
Press the [Scan] button to rotate the roller. Gently wipe the dirt and dust off while
taking care not to damage the surface of the rollers. Make sure that it is cleaned
properly because residue on the roller will affect the feeding performance.
Eject roller (× 2)
Press the [Scan] button to rotate the roller. Gently wipe the dirt and dust off while
taking care not to damage the surface of the rollers. Make sure that it is cleaned
properly because residue on the roller will affect the feeding performance.
HINT
Pressing the [Scan] button seven times will rotate the feed rollers and the eject rollers one
revolution.
Cleaning the Inside of the ScanSnap
449
Feed roller (×2)