Fujitsu Scan Snap S1300i Operator's Manual page 30

ScanSnap in sleep mode
When the ScanSnap has not been used for 1 minute while the power is on, it enters
sleep (power saving) mode.
The ScanSnap's internal light switches off in sleep mode.
ScanSnap's auto power off
When the ScanSnap is turned on and left unused for the specified time (default is "4
hours"), it will turn itself off automatically.
To turn the ScanSnap back on, perform one of the following operations:
Press the [Scan] button on the ScanSnap
Close the ADF paper chute (cover) and open it again
HINT
To continue using the ScanSnap, reset the time until auto power-off by performing one of the
following:
- Load a document in the ScanSnap
- Press the [Scan] button on the ScanSnap
- Close the ADF paper chute (cover) and open it again
You can change the time until the ScanSnap automatically turns off, or set the ScanSnap to not
automatically turn off by performing the following procedure:
1. Right-click the ScanSnap Manager icon
[Preferences] from the menu that appears.
The [ScanSnap Manager - Preferences] dialog box appears.
2. In the [Power] tab, select one of the setting items for [Power off after].
1. Click the ScanSnap Manager icon
the keyboard, and then select [Help]
The [ScanSnap Manager - Preferences] window appears.
2. In the [Power] tab, select one of the setting items for [Power off after].
Turning the ScanSnap ON/OFF
or on the taskbar, and then select [Help]
or in the Dock while pressing the [control] key on
[Preferences] from the menu that appears.
30