Alcatel-Lucent 7750 SR OS Configuration Manual page 47

Table 4: CLI Commands to Configure Basic IP Router Parameters (Continued)
Command
managed-
configuration
max-advertisement-
interval
min-advertisement-
interval
mtu
other-stateful-
configuration
prefix
autonomous
on-link
preferred-lifetime
valid-lifetime
reachable-time
retransmit-time
router-lifetime
no shutdown
Configure interface ICMP
config>router>interface
icmp
mask-reply
redirects
ttl-expired
unreachables
7750 SR OS Router Configuration Guide
Sets the managed address configuration flag. This flag indicates that
DHCPv6 is available for address configuration in addition to any address
autoconfigured using stateless address autoconfiguration.
Configures the maximum interval between sending router advertisement
messages.
Configures the minimum interval between sending ICMPv6 neighbor
discovery router advertisement messages.
Configures the MTU for the nodes to use to send packets on the link.
Sets the "Other configuration" flag. This flag indicates that DHCPv6lite is
available for autoconfiguration of other (non-address) information such as
DNS-related information or information on other servers in the network.
Configures an IPv6 prefix in the router advertisement messages.
Specifies whether the prefix can be used for stateless address
autoconfiguration.
Specifies whether the prefix can be used for onlink determination.
Configures the length of time that the prefix remains preferred.
Configures the length of time that the prefix is valid.
Configures how long this router should be considered reachable by other
nodes on the link after receiving a reachability confirmation.
Configures the retransmission frequency of neighbor solicitation
messages.
Sets the router lifetime.
Enables router advertisement on an interface.
Configures ICMP parameters on a network IP interface.
Enables responses to ICMP mask requests on the router interface.
Enables and configures the rate for ICMP redirect messages issued on the
router interface.
Configures the rate that ICMP TTL expired messages are issued by the
interface.
Enables and configures the rate for ICMP host and network destination
unreachable messages issued on the router interface.
IP Router Configuration
Description Page
116
117
117
117
118
118
118
119
119
119
119
120
120
120
109
109
109
110
110
Page 47