Alcatel-Lucent 7750 SR OS Configuration Manual page 118

Configuration Commands
Parameters mtu-bytes — Specify
other-stateful-configuration
Syntax [no] other-stateful-configuration
Description
This command sets the "Other configuration" flag. This flag indicates that DHCPv6lite is available
for autoconfiguration of other (non-address) information such as DNS-related information or
information on other servers in the network. See RFC 3736, Stateless Dynamic Host Configuration
Protocol (DHCP) for IPv6.
Default
no other-stateful-configuration
prefix
Syntax [no] prefix [ipv6-prefix/prefix-length]
Context config>router>router-advert>if
Description
This command configures an IPv6 prefix in the router advertisement messages. To support multiple
IPv6 prefixes, use multiple prefix statements. No prefix is advertised until explicitly configured using
prefix statements.
Default
none
Parameters
ip-prefix — The IP prefix for prefix list entry in dotted decimal notation.
prefix-length — Specifies a route must match the most significant bits and have a prefix length.
autonomous
Syntax [no] autonomous
Context config>router>router-advert>if>prefix
Description
This command specifies whether the prefix can be used for stateless address autoconfiguration.
Default
enabled
Page 118
the MTU for the nodes to use to send packets on the link.
Values
1280 — 9212
Values
ipv4-prefix
ipv4-prefix-length
ipv6-prefix
ipv6-prefix-length
Values 1 — 128
a.b.c.d (host bits must be 0)
0 — 32
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
0 — 128
7750 SR OS Router Configuration Guide