Common Configuration Tasks; Configuring A System Name - Alcatel-Lucent 7750 SR OS Configuration Manual

Common Configuration Tasks

The following sections describe basic system tasks.
•
•
•
•
•
•
•

Configuring a System Name

Use the
string. Only one system name can be configured. If multiple system names are configured, the last
one configured will overwrite the previous entry.
If special characters are included in the system name string, such as spaces, #, or ?, the entire string
must be enclosed in double quotes.
Use the following CLI syntax to configure the system name:
CLI Syntax: config# system
Example
7750 SR OS Router Configuration Guide
Configuring a System Name on page 49
Configuring Interfaces on page 51
→
Configuring a System Interface on page 51
→
Configuring a Network Interface on page 51
→
Configuring IPv6 Parameters on page 53
→
Router Advertisement on page 66
Configuring Proxy ARP on page 68
Creating an IP Address Range on page 71
Deriving the Router ID on page 72
Configuring a Confederation on page 73
Configuring an Autonomous System on page 75
command to configure a name for the device. The name is used in the prompt
system
name system-name
:
config# system
config>system# name
ALA-A>config>system# exit all
ALA-A#
IP Router Configuration
ALA-A
Page 49