List Of Commands; Table 4: Cli Commands To Configure Basic Ip Router Parameters - Alcatel-Lucent 7750 SR OS Configuration Manual

List of Commands

List of Commands
Table 4
configuration level at which each command is implemented with a short command description.
Refer to each specific chapter for specific routing protocol information and command syntax to
configure protocols such as OSPF and BGP.
The command list is organized in the following task-oriented manner:
•
•
•
•
•
•
•
•

Table 4: CLI Commands to Configure Basic IP Router Parameters

Command
Configure the system name
config>system
name
Configure the router ID
config>router
router-id
Configure router parameters
config>router
aggregate
Page 44
lists all the configuration commands to configure a 7750 SR-Series router, indicating the
Configure the system name
Configure the router ID
Configure router parameters
Configure a network interface
Configure the system interface
Configure IPv6 parameters on an interface
Configure router advertisement parameters
Configure interface ICMP
The system name for the device. Only one system name can be configured.
Configures the router ID for the router instance. When configuring a new
router ID, protocols will not automatically be restarted with the ID. The
next time a protocol is initialized, the new router ID is used. This may lead
to an interim period of time where different protocols use different router
IDs
Creates an aggregate route. Aggregate routes group a number of routes
with common prefixes into a single entry in the routing table, thereby
reducing the number of routes that need to be advertised by this router and
the routing tables of downstream routers.
Description
7750 SR OS Router Configuration Guide
Page
49
72
89
49
86