Air Conditioner Features - Kenmore 78183 Owner's Manual

AIR CONDITIONER FEATURES
The controls featured in this manual are
representative of the many models available. Your
model may look slightly different.
VERTICAL AIR DIRECTION CONTROL
The vertical air-direction is adjusted by moving the
upward or dowrward louver.
5 OFF
ME0
20
08
LOW_,\
|lJI
l/ME D
FAN
"_°O00L
LOWCOOL
TEMP MODE
TEMP
The thermostat will automatically control the
temperature of the room. Select a higher number for
lower room temperature. The temperature is
selected by turning the TEMP knob to the desired
position.
The 5 or 6 3osition is a normal setting for average
conditions.
MODE
OFF :
MED FAN
LOW FAN
HIGH COOL :
MED COOL :
LOW COOL :
Turns the air conditioner off.
Permits the medium fan speed
operation without cooling.
Permits the low fan speed operation
without cooling.
Permits cooling with the high fan
speed operation.
Permits cooling with the medium fan
speed operation.
Permits cooling with the low fan
speed operation.
VENT CONTROL
The Vent Control allows the air conditioner to either
recirculate inside air (CLOSE) or exhaust air to the
outside (OPEN).
• The CLOSE position is used when maximum
cooling is desired. It may also be used for air
recirculation without cooling when the air
conditioner is set in the FAN position.
• The OPEN position removes stale air from the
room and exhausts it to the outside. Fresh air is
drawn into the room through normal air passages
found in homes.
• The OPEN or CLOSE position can be used with
any fan selection.
PULL "__
DRAINAGE
A drain hole is provided at the rear of the air
conditioner unit. Select a drain method according to
the following.
• Remove the hole rubber from the base-pan.
• Connect a drain elbow of 9t16" inside diameter to
the drain pipe.
• Connect a drain hose of 9tl 6" inside diameter to the
drain elbow.(Drain hose is not supplied.)
_ ('ain p ipe
_ _ () ainpipe
\
Drain elb0w '_ Drain elb°w/ _
Drain hose
The air conditioner employs a proper drain method
whereby the condensed water (moisture removed from
the air) is drained to the outside. In very humid
weather, excessive condensed water removed from
the air may cause some water to collect. To remove
this excess water you can install the drain pan.
• Take the drain pan which is located in the air
discharge.
• Remove the hole rubber from the base-pan.
• Install the drain pan to the left corner of the cabinet
with 4(or 2) screws.
• Connect the drain hose to the outlet located at the
bottom of the drain pan. You can purchase the drain
hose or tubing locally to satisfy your particular needs.
(Drain hose is not supplied.)
Cabinet
//
i
&
Drain
I Drainpan
Screw
-11 -