Installation; Installation Requirements - Kenmore 78183 Owner's Manual

INSTALLATION REQUIREMENTS
Your air conditioner will install into standard double
hung windows with actual clear opening widths of
29 to 41 inches (737mm to 1041mm) (FIG. 1)
Lower sash must open sufficiently to allow a clear
vertical opening of 18 inches (457mm), Side louvers
and the rear of the air conditioner must have clear
air space to allow enough airflow through the
condenser for heat removal. The rear of the unit
must be outdoors, not inside a building or garage_
29" to
li"min ;',
ELECTRICAL SERVlCE
Check your available electrical service, The power
supply available must be the same as that shown on
the unit nameplate(found on right side of cabinet).
All models are equipp_ with a 3-prong service ptug
to provide proper service and safe positive
grounding Do not change plug in any way, Do not
use an adapter plug. if your present wall outlet does
not match your plug, call a qualified electrician to
make the necessary _rrections.
SAVE CARTON and this OWNER'S MANUAL for
future reference. The carton is the best way to store
unit during winter or when not in use,
To avoid risk of persona]injury, properlydamage,
or productdamagedue to the weight of this
device and sharp edgesthat may be exposed:
• Air conditionerscovered in this manual_se an
excessiveweight hazard.Two or more people
are neededto move and install the unit.
To prevent injuryor strain, use proper lifting and
carryingtechniqueswhen movingunit
• Cardully inspectlocationwhere air conditioner
will be installS.
Be sure it will support theweight of the unit over
an extendedperior of time.
• Handleair conditionerwith care. Wear
protectivegloves wheneverlifting or carryingthe
unit. AVOID the sharp metal fins of front and
rear coils.
• Make sure air conditionerdoes not fall during
installation.
INSTALLATION HARDWARE
FIG, 2
NO. NAME OF PARTS Q'TY
1 SIDE CURTAIN 2
2 SUPPORT BRACKET 2
3 SILL BRACKET 2
4 LOCK NUT 4
5 SCREW(TYPE A): 25/64" 14
6 SCREW(TYPE B): lS/id' 7
7 SCREW(TYPE C): 9/i6" 5
8 M-SCREW 2
9 CAR RtAGE BOLT 2
10 FOAM-PE 1
1i FOAM SEAL 1
12 UPPER GUIDE 1
13 FOAM-P E 1
14 WINDOW LOCKING BRACKET 1
i5 DRAIN PIPE 1
REQUIRED TOOLS:
• Tight Fitting gloves
• Standard screwdriver
• Phillips screwdriver
• Pliers
• Sharp knife
• Carpenters level
• 3!8-inch open end wrench or adjustable wrench
• 1!4qnch hex socket and ratchet
• Tape measure
• Electric drill
• 1/4-inch drill bit
-5 _