Procedure For Upgrading The Firmware (Engine Firmware/ Copier Firmware/ Fax Firmware/ Pcl Firmware) - Konica Minolta bizhub 160 Service Manual

Field Service Ver. 1.0 Apr. 2005
5. Select "Specify a location", and then click the [Browse...] button.
6. Specify "\Corresponding_language\Win9X" on the CD-ROM, and then click the [OK]
button.
7. Click the [OK] button, and then continue following the instructions in the dialog boxes
that appear until the "Completing the Found New Hardware Wizard" dialog box
appears.
8. Click the [Finish] button.
9. When the "Found New Hardware Wizard" dialog box appears again, repeat steps 4
through 8 to install all drivers.
5.2.2 Procedure for Upgrading the Firmware
(Engine firmware/ Copier firmware/ FAX firmware/ PCL firmware)
NOTE
• The engine firmware, Copier firmware, FAX firmware and PCL firmware can be
upgraded by using the following procedure.
• For the upgrading procedure of NIC firmware, see "NIC NC-501 Upgrading the
Firmware."
1. Turn on the printer.
2. Start up the host computer (Windows 98 or later).
3. Copy the "Update Software" folder and "Update" file to drive C. (Copy them into the
highest directory on drive C.)
4. Use a USB cable to connect the printer to the host computer. (Wait until the hardware is
detected.)
5. Display the "System Properties" dialog box ("Properties" for "My Computer"), click the
"Hardware" tab, click the [Device Manager] button, select "Imaging devices", and then
check that "KONICA MINOLTA 160 scanner" has been added.
6. Double-click "Update" file in the "Update Software" folder.
The "A3S/A4S Update F/W-VX.XX" dialog box appears.
4980D045AA
4980D047AA
5. Firmware upgrade
4980f2e001aa
23