Konica Minolta bizhub 160 Service Manual page 123

10. Utility Mode (bizhub 160f/bizhub 161f)
G. FOOTER
Functions / Use • This function can be used to set whether or not the reception information (RX
Setting/Procedure • The default setting is "OFF."
• Attaching footer print:
When Footer is selected ON, it is printed at the end of printable area. 4mm line area from
the end of printable area is kept for printing Footer. It should be attached on Footer area
regardless of image length. If the received image is divided into 2 pages or more, Footer
is printed in the specified location of all the recording sheets of paper printed.
• Image data area:
The received image data is printed on the area except for 12mm from recording paper
size. (No printable area: 8mm (1/3 in) + Footer area: 4mm (1/4 in)) The following table is
the image printable area of each recording paper size due to setting of Footer Print.
Paper length
A4 297 mm
Letter 279 mm
Legal 356 mm
H. SELECT TRAY
Functions / Use • This function can be used to select which paper tray can be used to supply
• This function is only available when an optional paper tray is installed.
Setting/Procedure • The default setting is "Enable."
• A non-equipped cassette is not displayed.
90
data and time, RX management number, RX page number, Transmitter's ID) is
printed at the bottom of each received document.
ON : Add footer
"OFF" : No footer
Footer off
Image data area
289 mm
271 mm
348 mm
paper when printing received documents or transmission reports. (A paper tray
that cannot be used for supplying paper can also be specified.)
Tray1 : "Enable"
Tray2 : "Enable"
When setting value is determined, reception setting of utility menu is indicated.
This setting has effect on RX print and Report print.
Field Service Ver. 1.0 Apr. 2005
Image data area
285 mm
267 mm
344 mm
Disable
Disable
Footer on
Footer area
+4 mm (1/4 in)
+4 mm (1/4 in)
+4 mm (1/4 in)