Carved Fill Properties - Brother BES Lettering Instruction Manual

Carved Fill Properties

In addition to the density and stitch-length settings described
above there are a few extra fill settings that apply only to the
Carved fills. You can adjust these Carved pattern settings in the
Properties box. The settings allow you to change a fill pattern's
characteristics such as the size and angle of the fill pattern.
The following figures show some different effects you can
create using the Carved Fill settings.
Original (scale at 100%)
To change the Emboss Scale of a Carved pattern:
1 Select a Carved fill segment
2 In the Fill area of the Properties Panel, do the following:
 Click the Emboss Scale box to select this property.
 In the Emboss Scale field, enter a percentage value to
adjust the scaling.
3 Click Apply.
To change the Emboss Angle of a Carved pattern:
1 Select a Carved fill segment
2 In the Fill area of the Properties Panel, do the following:
 Click the Emboss Angle box to select this property.
 In the Emboss Angle field, enter a percentage value to
adjust the angle.
3 Click Apply.
You see your segment altered accordingly.
Text Properties
Emboss Scale at 50%
79