One Push Configuration Using Wps (Wi-Fi Protected Setup) Or Aoss - Brother HL-S7000DN Network User's Manual

Configuring your machine for a wireless network
One push configuration using WPS (Wi-Fi Protected Setup) or
AOSS™
You can use WPS or AOSS™ from the control panel menu to configure your wireless network settings if your
WLAN access point/router (A) supports either WPS (PBC
1
Push Button Configuration
Important
• If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation. You must know your wireless network settings before you
proceed with this installation.
• If you have previously configured the wireless settings of the machine, you must reset the LAN settings
before you can configure the wireless settings again.
To reset the LAN settings, see Reset the network settings to the factory default uu page 36.
• Your Brother machine supports the use of the first WEP key only.
a
Press Menu.
b
Press a or b to choose Network.
Press OK.
c
Press a or b to choose WLAN.
Press OK.
d
Press a or b to choose WPS/AOSS.
Press OK.
e
When WLAN Enable? is displayed, press a or b to choose On and then press OK.
This will start the wireless setup wizard.
To cancel, press Cancel.
1
) or AOSS™.
3
3
22