Wireless Configuration Temporarily Using A Usb Cable (Recommended For Windows ® ) - Brother HL-S7000DN Network User's Manual

Configuring your machine for a wireless network
Wireless configuration temporarily using a USB cable
(Recommended for Windows
It is recommended that you use a PC wirelessly connected to your network for this method.
You can remotely configure the machine from the computer on the network using a USB cable (A)
1
You can configure the wireless settings of the machine using a USB cable temporarily connected to a wired or wireless computer.
Important
• The following instructions will install your Brother machine in a network environment using the Brother
installer application found on the CD-ROM we have provided with the machine.
• If you have previously configured the wireless settings of the machine, you must reset the LAN settings
before you can configure the wireless settings again.
To reset the LAN settings, see Reset the network settings to the factory default uu page 36.
• If you are using the Windows
temporarily disable them. Once you are sure that you can print please re-enable your firewall.
• You need to temporarily use a USB cable during configuration.
• You must know your wireless network settings before you proceed with this installation.
If you are going to connect your Brother machine to your network, we recommend that you contact your
system administrator prior to installation.
• If your access point/router uses WEP encryption, enter the key used as the first WEP key. Your Brother
machine supports the use of the first WEP key only.
a
Before configuring your machine we recommend you write down your wireless network settings. You will
need this information before you continue with the configuration.
For a personal wireless network configuration
If you are configuring your machine for a smaller wireless network, such as your home environment,
record your SSID and the Network Key.
®
)
®
Firewall or a firewall function of anti-spyware or antivirus applications,
3
1
.
3
3
10