Mac Address; Set To Default; Wired Enable; Wlan Enable - Brother HL-S7000DN Network User's Manual

Control panel setup

MAC Address

The MAC address is a unique number assigned for the machine's network interface. You can check your
machine's MAC address from the control panel.

Set to Default

The Set to Default allows you to reset each wired or wireless settings to the factory default. If you want
to reset both wired and wireless settings, see Reset the network settings to the factory default uu page 36.

Wired Enable

If you want to use the wired network connection, set Wired Enable to On.

WLAN Enable

If you want to use the wireless network connection, set WLAN Enable to On.
Note
If a network cable is connected to your machine, set Wired Enable to Off.

IPsec

To enable IPsec, set IPsec to On.
If you want to change the default factory settings, please refer to the IPsec Setting Guide located on the
Manuals page for your model on the Brother Solutions Center (http://solutions.brother.com/) for details.
4
4
4
4
4
4
35