Brother HL-S7000DN Network User's Manual page 31

Configuring your machine for a wireless network
a
Press Menu.
b
Press a or b to choose Network. Press OK.
c
Press a or b to choose WLAN. Press OK.
d
Press a or b to choose WPS w/PIN Code. Press OK.
e
When WLAN Enable? is displayed, press a or b to choose On and then press OK.
This will start the wireless setup wizard.
To cancel, press Cancel.
f
The LCD will show an 8 digit PIN and the machine starts searching for a WLAN access point/router.
g
Using a computer that is on the network, type "http://access point's IP address/" into your browser.
(Where "access point's IP address" is the IP address of the device that is used as the Registrar
the WPS setting page and input the PIN which the LCD shows in step f to the Registrar and follow the
on-screen instructions.
1
The Registrar is normally the WLAN access point/router.
Note
The setting page is different, depending on the brand of WLAN access point/router. See the instructions
supplied with your WLAN access point/router.
®
Windows Vista /Windows
If you are using your computer as a Registrar, follow these steps:
Note
• To use a Windows Vista
in advance. See the instructions supplied with your WLAN access point/router.
®
• If you use Windows
following the on-screen instructions. If you want to install the full driver and software package, follow the
steps uu Quick Setup Guide for installation.
1
(Windows Vista
Click the button and then Network.
®
(Windows 7)
Click the button and then Devices and Printers.
2
(Windows Vista
Click Add a wireless device.
®
(Windows 7)
Click Add a device.
3
Choose your machine and click Next.
4
Input the PIN which the LCD shows in step f and then click Next.
®
7
® ®
or Windows 7 computer as a Registrar, you need to register it to your network
7 as a Registrar, you can install the printer driver after the wireless configuration by
®
)
®
)
3
1
.) Go to
3
25