Tcp/Ip Menu - Dell B5465dnf Mono Laser Printer MFP User Manual

Understanding the printer menus
Use
Job Timeout
0, 10–225 seconds
Banner Page
Off
On

TCP/IP menu

To access the menu, navigate to either of the following:
•
Network/Ports > Standard Network > Standard Network Setup > TCP/IP
• Network/Ports > Network [x] > Network [x] Setup > TCP/IP
Note: This menu is available only in network printers or printers attached to print servers.
Use
Set Hostname
IP Address
Netmask
Gateway
Enable DHCP
On
Off
Enable RARP
On
Off
Enable BOOTP
On
Off
Enable AutoIP
Yes
No
Enable FTP/TFTP
Yes
No
To
Set the amount of time it takes for a network print job to be canceled.
Notes:
•
"90 seconds" is the factory default setting.
•
A setting value of 0 disables the timeout.
•
If a value between 1 and 9 is selected, then Invalid appears on the
display, and the value is not saved.
Allow the printer to print a banner page.
Note: Off is the factory default setting.
To
Set the current TCP/IP host name.
Note: This can be changed only from the Embedded Web Server.
View or change the current TCP/IP address.
Note: Manually setting the IP address sets the Enable DHCP and Enable Auto IP
settings to Off. It also sets Enable BOOTP and Enable RARP to Off on systems that
support BOOTP and RARP.
View or change the current TCP/IP netmask.
View or change the current TCP/IP gateway.
Specify the DHCP address and parameter assignment.
Note: On is the factory default setting.
Specify the RARP address assignment setting.
Note: Off is the factory default setting.
Specify the BOOTP address assignment setting.
Note: On is the factory default setting.
Specify the Zero Configuration Networking setting.
Note: Yes is the factory default setting.
Enable the built-in FTP server, which lets you send files to the printer using File Transfer
Protocol.
Note: Yes is the factory default setting.
162