Configuring Tcp/Ip - Dell 2335dn User Manual

3.
The Network Configuration page prints out.
Setting Network Protocols
When you first install and power up the printer, all supported network protocols are enabled. If a network
protocol is enabled , the printer may actively transmit on the network even when the protocol is not in use.
This may slightly increase network traffic. To eliminate unnecessary traffic, you may disable unused
protocols.
1. Press Scroll (
2. Press Scroll (
3. Press Scroll (
4. If you selected Ethernet Speed , select a network speed.
If you selected TCP/IP (IPv4) or TCP/IP (IPv6) , assign a TCP/IP address. For details, see

"Configuring TCP/IP" .

If you selected AppleTalk .
a. Press Scroll (
b. Press Scroll (
NOTE: When you set AppleTalk, you must restart your machine to apply new
settings.
5. Press Select (
Configuring TCP/IP
Static Addressing: TCP/IP address is assigned manually by the system administrator.
Dynamic Addressing BOOTP/DHCP (default): TCP/IP address is assigned automatically by a DHCP or
BOOTP server on your network.
NOTE: Only the system administrator can set the IP address for TCP/IP (IPv6) .
Setting TCP/IP
1.
Downloaded from ManualsPrinter.com Manuals
or ) to highlight Setup and then press Select (
or ) to highlight Network Setup and then press Select (
or ) until you see the desired protocol and then press Select (
or ) to select Activate and then press Select (
or ) to change the setting to On (enable) or Off (disable).
) to save the selection.
).
).
).
).