Oki MC780f User Manual page 175

8 [Administration] Tab Page
[Add Filter] / [Modify Filter] screen
You can display this screen by clicking the [Add] button for Filter or a registered filter name.
You can create a filter to use in IPsec.
1
2
3
4
5
6
7
8
9
10
11
1
2
3
4
5
6
7
8
9
10
11
Item name
1 [OK] button
2 [Cancel] button
3 [Reset] button
4 Filter Name
5 Internet Protocol Version
6 Source Address
7 Destination Address
8 Protocol Type
174 [Setup] Item List
Saves the folder setting.
Cancels registration of the folder.
Returns the settings to the defaults.
Enter a filter name. You can enter up to 63 alphanumerical characters and symbols other
than #, %, &, +, \ (backslash), ' (apostrophe), ; (semicolon), , (comma), ", and =.
Select the IP version for IPsec.
IPv4 — Select this to use IPsec under the IPv4 environment.
IPv6 — Select this to use IPsec under the IPv6 environment.
The IP address of this equipment is set as the source address to which the filter is applied.
[My IP Address] is displayed in this box. This item cannot be changed.
Specify the destination address for the communication to which the filter is applied.
Specific IP Address — Set a specific IP address. Enter the IP address in the address
input box.
Subnet / Prefix — Set the destination with its IP address and subnet mask. Enter the IP
address and the prefix of the subnet mask directly in the address input box.
FQDN — Sets FQDN for the destination. Enter FQDN in the address input box. You can
enter up to 255 alphanumerical characters including hyphen (-) and period (.). However,
neither hyphen (-) nor period (.) can be used as first or last character.
Any IP Address — Set any IP address.
Select a protocol for the filter.
Any — Set any protocol.
TCP — Select this to use TCP only.
UDP — Select this to use UDP only.
ICMP — Select this to use ICMP only.
Description