Ricoh SP 5200S Operating Instructions Manual page 219

Message
MIC failure TKIP counter measures started
MIC failure TKIP counter measures stopped
Name registration failed. name=<NetBIOS
name>
Name registration success in Broadcast
name=<NetBIOS name>
Name registration success. WINS server=<WINS
server address> NetBIOS Name=<NetBIOS
name>
nbtd start.
no RADIUS/authentication server
no smart card detected on device
no SSID in scan result
no WPA information element in probe response,
rescanning
npriter start. (NetWare)
nwstart start. (NetWare)
Problem and solutions
The supplicant using TKIP has detected two
instances of tampering within 60 seconds and has
started counter measures.
Counter measures have stopped after 60 seconds
(since the supplicant using TKIP started counter
measures against tampering).
Name registration of <NetBIOS Name> failed.
Change to a different NetBIOS name.
Name registration by <NetBIOS Name>
broadcast was successful.
Name registration of <NetBIOS Name> to
<WINS server address> was successful.
The nbtd (NetBIOS over TCP/IP Daemon) has
started.
The supplicant has received a message reporting
that a usable RADIUS server cannot be found.
PEAP/GTC (Generic Token Card) is selected, but
a smart card using GTC authentication cannot be
found.
A network with the SSID you specified was not
found.
The specified SSID might not be available, or the
signal from the access point/multi-channel might
be weak.
There is no WPA information on the response
from the SSID probe of the access point you want
to use. The supplicant is rescanning.
(In the remote printer mode) The NetWare
service has started.
The NetWare protocol stack setup server has
started.
Message List
4
217