Netware Printing - Ricoh SP 5200S Operating Instructions Manual

7. Appendix
If the machine is connected to a network, observe the following points when setting up the machine or
changing settings:
For more details, see the operating instructions and Help for the ScanRouter delivery software and
DeskTopBinder.
When a dial-up router is connected in a network environment
The settings for the delivery server to be connected must be made appropriately for the machine
with the ScanRouter delivery software, Auto Document Link, or DeskTopBinder. In addition, set up
connected devices using the I/O settings of the ScanRouter delivery software administration utility.
If the network environment changes, make the necessary changes for the delivery server using the
machine, the administration utility of client computers, Auto Document Link, and DeskTopBinder.
Also, set the correct information for the connected devices using the I/O settings of the ScanRouter
delivery software administration utility.
When connected to a computer that uses dial-up access
• Do not install the ScanRouter delivery software on a computer which uses dial-up access.
• When using the ScanRouter delivery software, DeskTopBinder, Auto Document Link, or a
TWAIN driver on a computer with dial-up access, a dial-up connection may be performed
when connecting to the delivery server and other equipment, depending on the setup. If the
computer is set up to connect to the Internet automatically, the confirmation dialog box will not
appear, and telephone charges may be incurred without your being aware of it. To prevent
7
unnecessary connections, the computer should be set up so the confirmation dialog box
always appears before establishing a connection. Do not make unnecessary connections
when using the above listed software.

NetWare Printing

• IPv6 cannot be used on this function.
Form feed
You should not configure form feed on NetWare. Form feed is controlled by the printer driver on
Windows. If NetWare form feed is configured, the printer might not work properly. If you want to
change form feed settings, always configure them using Windows.
• Under Windows XP and Windows Server 2003/2003 R2, clear the [Form feed] check box on the
[NetWare Settings] tab in the printer properties dialog box.
310