Connecting To The Ethernet Interface (Mainly North America) - Ricoh SP 5200S Operating Instructions Manual

4. Connect the other end of the Ethernet interface cable to a network connection device such
as a hub.
5. Turn on the main power switch of the machine.
1. Indicators
When 100BASE-TX or 10BASE-T is operating, the green LED is lit and the orange LED flashes. If the
machine is not connected to the network, both LEDs are turned off.
• For details about how to turn on the main power switch, see "Turning On/Off the Power", About
This Machine.
• For details about installing the printer driver, see "Preparing the Machine", Printer Reference.
Connecting to the Ethernet Interface
This section describes how to connect an Ethernet cable to the Ethernet interface.
• If the main power switch is on, turn it off.
• Use the following Ethernet cables:
• Unshielded Twisted Pair Cable (UTP) or Shielded Twisted Pair Cable (STP) and Category type
5 or more
1. Make sure the main power is switched off.
1
CFL014
(mainly North America)
Connecting to the Interface
2
73