Draining And Disposing Of Waste Oil - Frymaster RE E4 Installation & Operation Manual

3. Allow all filter assembly components to air dry or thoroughly dry with clean towels before
reassembling.
Reassembly
1. Place the two outer screens together and align their edges (see illustration on following page).
2. Insert the screens into one of the frame halves (it doesn't matter which one). Ensure that the
fitting in the bottom screen is on the opposite side of the frame from the handle.
3. Slip the grid between the screens, ensuring that the grid is centered between the edges of the
screens.
4. Connect the other half of the frame at the corner opposite the handles and pivot the frame onto
the free edges of the screen.
Handle
4.5

Draining and Disposing of Waste Oil

When your oil has reached the end of its usable life, drain the oil into an appropriate METAL
container for transport to the disposal container. Frymaster recommends the use of the Frymaster
Shortening Disposal Unit (SDU). NOTE: If using an SDU built before January 2004 the filter pan
cover must be removed to allow the unit to be positioned beneath the drain. To remove the lid, lift up
on the front edge and pull it straight out of the cabinet. Refer to the documentation furnished with
your disposal unit for specific operating instructions. If a shortening disposal unit is not available,
allow the oil to cool to 100°F (38°C), then drain the oil into a metal stockpot or similar metal
container. When draining is finished, close the fryer drain valve securely.
Allow oil to cool to 100°F (38°C) before draining into an appropriate METAL
container for disposal.
When draining oil into a disposal unit, do not fill above the maximum fill line located
on the container.
Steps 1 and 2 - Stack outer screens
and insert edges into frame.
Step 3 - Insert grid between screens
after screens have been positioned in
frame.
DANGER
4-8
Step 4 - Connect corner then pivot
frame over free edges of screens.