If Your Copier Does Not Operate As You Want - Ricoh FT3813, FT4615, FT4618 Operating Instructions Manual

IF YOUR COPIER DOES NOT OPERATE AS YOU WANT

IF YOUR COPIER DOES NOT OPERATE AS
Check the followings:
Copier's condition
Nothing happens when the main
switch is turned on.
"PE" is displayed on the copy counter. Load paper.
f
is blinking or lit.
Y
is lit.
Energy Saver is lit.
U code is displayed on the
copy counter.
"E" and a number are alternately
displayed on the copy counter.
46
Check the power cord. Is it properly plugged
into the outlet?
Plug it in firmly.
See page 49 ~ 50.
Add toner. See page 51.
Remove misfed paper.
Your machine is in the Energy Saver condition.
Press any key except the Start key to
return to the ready condition.
U1 Close the right side cover.
The copier is set for user codes. Enter your user
U2
codes. (3 digits)
U4 Reset the optional sorter correctly.
U6 Call your service representative.
Turn the main switch off, wait a few seconds,
and then turn it on. If the E code appears again,
call your service representative and tell which
code is on.
KF2Jr-AE-7
YOU WANT
Action
See page 52 ~ 54.