Adjusting The Image - Polaroid Polaview 305 User Manual

Polaroid projectors user guide

Table of Contents

Reverting to the

factory defaults

Adjusting the image

Adjusting the

brightness

Adjusting the

contrast

Correcting shimmering

or streaks

If you want to revert to the original factory settings for a

specific computer source, choose Image, Factory Defaults,

Reset.

To reset the projector itself, press the CLEAR key, then press

each of the four arrow keys on the projector control panel

once. The power LED indicator blinks twice to indicate the

projector has been reset.

Press the SETUP key to gain access to most of the settings

you need to adjust the image.

Note: The choices on the Setup menu vary, depending on

your current input source.

To adjust the brightness, press the SETUP key until the

Brightness slider appears. Press the edges of the

MouseDisk, use the optional Cyclops wand or laser pointer,

or press the left and right arrow keys to move the slider.

You can also adjust the brightness by opening the projector

menus and choosing Bright from the Image menu.

To adjust the contrast, press the SETUP key until the

Contrast slider appears. Press the edges of the MouseDisk,

use the optional Cyclops wand or laser pointer, or press the

left and right arrow keys to move the slider.

You can also adjust the contrast by opening the projector

menus and choosing Contrast from the Image menu.

If your projected image has horizontal streaks, or seems to

shimmer slightly, adjust the Sync setting. (This setting is

only active when the source is your computer.)

Press the SETUP key until the Sync slider appears. Press the

edges of the MouseDisk, use the optional Cyclops wand or

laser pointer, or press the left and right arrow keys to move

the slider. Repeat until the streaks disappear.

Using the projector 51

Table of Contents