Polaroid Polaview 305 User Manual page 16

10 Introduction
Connecting
video and audio
To set this up: Connect this cable:
Video from Composite
VCR/ laserdisc audio/video
cable (C497-6)
Video from S-video cable
S-video (C466-6)
device
Audio from Composite
VCR/laserdisc audio/video
cable
(C497-6)
Audio from Computer
computer audio
cable
(C498-6)
DEC workstations
1 Disconnect your computer-to-monitor cable at the comput-
er end.
2 Connect the free end of the monitor cable to the DEC 3C3-to-
LCD adapter (part number C946).
3 Connect the free end of the DEC 3C3-to-LCD adapter to the
projector COMPUTER OUT connector.
4 Use the DEC 3C3-to-LCD connector cable (part number
C946-6) to link the projector to the computer. Connect the
end marked LCD to the projector COMPUTER IN connector,
and the end marked COMPUTER to the workstation video-
output connector.
Proceed to the next section, Connecting video and audio .
Connect audio and video sources to the projector, using this
table as a guide. If you need more information, see the
appropriate section in Chapter 2, Detailed setup .
From here:
VIDEO 1, 2
ports on
projector
S-VIDEO 1, 2
ports on
projector
AUDIO IN 1, 2
ports on projector
(red = right,
white = left)
Left/right
COMPUTER
AUDIO IN ports
on projector
To here:
RCA port on
VCR marked
VIDEO OUT
or some-
thing similar
VIDEO OUT
port on
S-video
device
AUDIO OUT
port on VCR
(red = right,
white = left)
AUDIO OUT
port of the
Mac or the
sound card
of a PC