Table of Contents
Advertisement
52 Using the projector
Correcting
vertical banding
Adjusting the color
tint and saturation
Adjusting image
position
Switching to rear
projection mode
You can also adjust the sync by opening the projector
menus and choosing Sync from the Image menu.
If the projected image has vertical black lines or bands,
adjust the Dot Clock (DotClk..) setting on the Image menu to
eliminate them. (This setting is only available when the
source is your computer.)
To correct the tint, press the SETUP key and adjust the slide
bar for the Tint setting (availability depends on your current
input source).
If you prefer, you can also adjust the Red, Green, and Blue
settings on the Image menu (while the computer or Adobe
Acrobat Player System is the input source) or the Tint set-
ting (while video or S-video is the input source).
To move the on-screen image, press the SETUP key and
adjust the slide bar for Hor. Pos. (Horizontal Position) or
Vert. Pos. (Vertical Position). You can also find these settings
on the Advanced menu.
To switch to rear projection mode (projecting from behind
the projection screen instead of in front of the screen),
choose Projection, Rear from the Projector menu.
Advertisement
Table of Contents
