6 Gently tilt the flip mirror approximately 45˚. (You can adjust
Tilting the flip mirror
to a 45 degree angle
Connecting the
computer
1 Disconnect your computer-to-monitor cable at the computer
2 Connect the free end of the monitor cable to the VGA OUT
3 Use the Polaview VGA-to-LCD connector cable (part number
the angle later to raise or lower the projected image.)
Caution: Never push on or force the mirror. Always use
care when opening the mirror assembly. Avoid touching the
surface of the mirror with your fingers.
Follow the instructions specific to your hardware.
Connecting PCs
end.
connector on the projector.
C800-6) to link the projector to the computer. Connect the
end of the cable marked LCD to the projector COMPUTER IN
connector, and the end marked COMPUTER to the comput-
er video-output connector.
Proceed to the section Connecting video and audio .
Introduction 7