Electronic Eraser - Panasonic Panaboard KX-BP800U Operating Instructions Manual

Precautions
Power cord
and Interactive
cable
Replacing the
Thermal
transfer film
Electronic
Pen and
Electronic
Eraser
10
• Before moving the unit, disconnect the power cord from the electrical power
socket and AC inlet, and disconnect the interactive cable from the
interactive connector and a PC. Then coil them for transportation. Failure to
do these cause the cord and cable to be damaged if they are stepped on or
if they catch on something while the unit is being moved.
• Dispose of the used thermal transfer film in a trash receptacle for burnable
trash.
• A negative of the copied image will remain on the thermal transfer film.
(To protect the security of your information, we recommend cutting up used
thermal transfer film with scissors or shredder before disposing of it.)
• Do not cover the transmitter with your hand while using an interactive
function as this may cause the position of the Electronic Pen or the
Electronic Eraser not to be normally detected.
NG
• Press down firmly with the point of the Electronic Pen or the eraser cloth of
the Electronic Eraser on the screen film until you hear a buzzing sound, and
then move it slowly.
However, do not press down the point of the Electronic Pen too much
strongly as this may make a dent in the screen back panel.
• Do not use two or more the Electronic Pens or the Electronic Eraser at the
same time as this may cause the position of the Electronic Pen or the
Electronic Eraser not to be normally detected.
• For precise positioning, keep the Electronic Pen and Electronic Eraser
perpendicularly to the screen during use.
• Since ultrasonic is used to detect the position of the Electronic Pen and
Electronic Eraser when they are being used, you may hear a buzzing
sound, but this is not harmful to the human body or peripheral hardware.
It will also not result in an electric shock.
Transmitter
OK