Panasonic Panaboard KX-BP800U Operating Instructions Manual page 3

Interactive electronic print board
Table of Contents

Advertisement

WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT
EXPOSE THIS PRODUCT TO RAIN OR ANY TYPE OF
MOISTURE.
THE SOCKET-OUTLET MUST BE NEAR THIS EQUIPMENT AND MUST BE EASILY ACCESSIBLE.
The product should be used only with the power cord that is supplied by the manufacturer.
Safety Information
This appliance is supplied with a moulded three pin mains plug for your safety and convenience.
A 5 amp. fuse is fitted in this plug. Should the fuse need to be replaced please ensure that the replacement
fuse has a rating of 5 amps. and that it is approved by ASTA or BSI to BS1362. Check for the ASTA mark
or the BSI mark
that it is refitted when the fuse is replaced. If you lose the fuse cover the plug must not be used until a
replacement cover is obtained. A replacement fuse cover can be purchased from your local Panasonic Dealer.
If the fitted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed and
the plug cut off and disposed of safely.
There is a danger of severe electrical shock if the cut off plug is inserted into any 13 amp. socket.
If a new plug is to be fitted please observe the wiring code as shown below. If in any doubt please consult a
qualified electrician.
WARNING
: This appliance must be earthed.
IMPORTANT : The wires in this mains lead are coloured in accordance with the following code.
Green-and-Yellow : Earth
Blue
Brown
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows.
The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is marked with
the letter E or by the Earth symbol
The wire which is coloured Blue must be connected to the terminal in the plug which is marked with the letter N
or coloured Black.
The wire which is coloured Brown must be connected to the terminal in the plug which is marked with the letter L
or coloured Red.
How to replace the fuse : [KX-BP800U only]
Open the fuse compartment with a screwdriver and
replace the fuse.
For users in the United Kingdom only
on the body of the fuse. If the plug contains a removable fuse cover you must ensure
: Neutral
: Live
or coloured Green or Green-and-Yellow.
CAUTION:
TO PREVENT RISK OF ELECTRIC SHOCK HAZARD, DO
NOT REMOVE THE COVER OF THIS PRODUCT, REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
FUSE
3

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents