Panasonic Panaboard KX-BP800U Operating Instructions Manual page 15

4
Load the thermal transfer film into the film
cassette.
• Load the thermal transfer film into the film
cassette so that the blue gear inserted in the
thermal transfer film is located on the blue
label side of the film cassette. Push in the
direction of the arrow until you hear all four
gear shafts click in place.
5
If the thermal transfer film is slack, take up
the slack by winding the gears on the label
side of the cassette in the direction of the
arrows.
• The multi-copy / error indicator may flash
" " if the thermal transfer film is slack. In
addition, the thermal transfer film may
wrinkle, and blank (unprinted) spots or black
streaks may appear on the copy paper.
6
Install the film cassette.
• Insert the film cassette into the printer so
that the blue gear on the cassette aligns with
the blue label on the printer and then insert
the gear shafts on both sides of the cassette
into the grooves inside the printer.
• If the film is slack after loading the film
cassette, take up the slack in the same
manner described in step 5 while the
cassette remains loaded.
7
Close the printer door.
• Securely close the printer door by using both
hands until a click is heard.
• The " " flashing on the multi-copy / error
indicator will go out.
Note
• If the flashing " " does not go out even
though the printer door has been closed, this
indicates that the film cassette has not been
installed properly or that there is slack in the
thermal transfer film. Check the condition of
the film cassette and for slack in the thermal
transfer film.
Installing Thermal Transfer Film
Blue Label
Thermal
Transfer Film
Load thermal transfer
film in this direction
Blue Gear
Film Cassette
Label
Slack Prohibited
Blue Label
Grooves
Thermal
Transfer Film
Grooves
Printer Door
15