Epson Stylus Photo 700 User Manual page 170

To make DMA transfer available, see below.
1. Double-click the My Computer icon, double-click
the Printer icon, right-click EPSON Stylus Photo 700, and
select Property. The printer driver window appears.
2. Click the Utility tab and click the Speed & Progress button
on the Utility menu. The Speed & Progress dialog box
appears.
3. If a message appears on the Speed & Progress dialog box,
compare it with the table below.
Message
High Speed (DMA) Transfer
enabled.
For higher data transfer rates,
use DMA Transfer.
<No message>
4. Double-click the My Computer icon and double-click
Control Panel.
5. Double-click the System icon and click the Device Manager
tab.
6. Double-click the Ports (COM & LPT) icon and double-click
LPT1. If you have connected your printer to a port other
than LPT1, double-click the appropriate port icon.
Action
DMA transfer is already enabled. Click
OK to close the dialog box.
Go to step 4.
Your system cannot use DMA transfer.
However if you change the parallel
port setting to ECP or Enhanced using
your computer's BIOS Setup program,
you may be able to use DMA transfer.
Consult your computer's manual or
computer maker for instructions.
Note:
Before you run the BIOS Setup program,
uninstall the printer software. After running
the Setup program, reinstall the printer
software.
Troubleshooting
8
8-27