Epson Stylus Photo 700 User Manual page 158

The printer loads more than one sheet at a time.
Cause
Too many sheets are loaded
in the sheet feeder.
The edge guides are not set
correctly.
The paper was not fanned
before being loaded in the
sheet feeder.
The edges of the paper stack
are not even.
The paper is too thin.
Ejected paper is wrinkled.
Cause
The paper is damp.
The paper is too thin.
What to do
Take the paper stack out of the feeder,
remove some sheets, and reload paper.
Before you load paper, see page 6-4 to
check the amount of paper you can
load in the sheet feeder.
Adjust the guides against the stack of
paper. See "Loading Paper" on page
3-2.
Remove the paper stack and fan it.
Tap it on a flat surface to even the
edges. Then reload the paper.
Remove the paper stack and tap it on a
flat surface to even the edges. Then
reload the paper.
Make sure the paper meets the paper
requirements for this printer. See
"Paper" on page B-2.
What to do
Do not store your paper in a damp or
humid environment. Store paper in its
original packaging.
Make sure the paper meets the paper
requirements for this printer. See
"Paper" on page B-2.
Troubleshooting
8
8-15