Paper Handling - Epson Stylus Photo 700 User Manual

Paper handling

Paper does not feed properly from the sheet feeder.
Cause
Too many sheets are loaded
in the sheet feeder.
The edge guides are not set
correctly.
Paper is jammed in the paper
path.
The paper stack does not fit
under the edge guide tab
inside the left edge guide.
The paper is curled or folded. Use flat, undamaged paper.
The paper is old or creased.
The paper's size is not
compatible with the printer.
8-14
Troubleshooting
What to do
Take the paper stack out of the feeder,
remove some sheets, and reload the
stack. Before you load paper, see page
6-4 to check the amount of paper you
can load in the sheet feeder.
Adjust the guides against the stack of
paper. See "Loading Paper" on page
3-2.
Take all the paper out of the sheet
feeder, reload the paper, then press the
E
load/eject button. If the
light continues to flash, turn off the
printer and gently pull out any paper
that may be jammed in the printer. If it
tears and pieces remain inside the
printer, open the printer cover; then
remove the pieces of paper.
Reload the paper so that it fits under
the edge guide tab. See "Loading
Paper" on page 3-2.
Use only new, smooth sheets of paper.
Use paper that meets the paper
requirements for this printer. See
"Paper" on page B-2.
S
paper out