Connecting The Printer To Your Macintosh - Epson Stylus Photo 700 User Manual

Connecting the Printer to Your Macintosh

To use the printer's built-in serial interface, you will need
an Apple System Peripheral-8 cable. Read the following steps
to connect the printer to your Macintosh:
1. Make sure both your printer and Macintosh are turned off.
2. Connect one end of the interface cable to the serial connector
on the back of the printer.
3. Connect the other end of the interface cable to either the
modem port or printer port on the Macintosh. The ports are
marked with the following icons.
4. Turn on the printer by pressing the P power button.
5. Turn on your Macintosh.
See the next page for instructions on installing the printer
software. You must install the printer software before using
your printer.
modem port
printer port
Getting Started
2
2-25