Ports Descriptions - Patton electronics SMARTNODE 4110 Series Getting Started Manual

Model 4520 & 4110 Series Getting Started Guide

Ports descriptions

The SmartNode 4110 Series rear panel ports are described in
Port
10/100 Ethernet Rear panel RJ-45 connector (see
ETH 0/0
Voice Ports, FXS Rear panel FXS RJ-11/12 connectors (see
Power Rear panel The gateway is available in a DC or AC power input version (see
Console Front panel Used for service and maintenance, the Console port (see
SmartNode Series VoIP routers overview
Table 4. Rear panel ports
Location
Ethernet device (a cable or DSL modem, LAN hub or switch, for example).
with an FXO port (a telephone for example). EuroPOTS support (ETSI
EG201 188). Configured per model as follows:
Model 4112—0/0, 0/1
•
Model 4114—0/0, 0/1, 0/2, 0/3
•
Model 4116—0/0, 0/1, 0/2, 0/3, 0/4, 0/5
•
• Model 4118—0/0, 0/1, 0/2, 0/3, 0/4, 0/5, 0/6, 0/7
), labeled as follows:
figure 6
• AC version (Internal power supply): 100–240 VAC, 50/60 Hz
AC version (External power supply): 100–240 VAC, 50/60 Hz
•
• DC version: 12 VDC
an RS-232 RJ-45 connector, connects the router to a serial terminal such as a PC
or ASCII terminal (also called a dumb terminal).
Figure 6. SmartNode 4110 Series power input connectors
table 4.
Description
on page 20) that connects the router to an
figure 5
on page 20) that connect the router
figure 5
1 • General information
figure 7 on page 22),
21