Installing The Ethernet Cable - Patton electronics SMARTNODE 4110 Series Getting Started Manual

3 • Installation

Installing the Ethernet cable

The SmartNode 4520 Series has automatic MDX (auto-cross-over) detection and configuration on the Ether-
net ports. Any of the two ports can be connected to a host or hub/switch with a straight-through wired cable
(see figure 17). Ethernet devices (10Base-T or 100Base-T) are connected to the SmartNode's Ethernet ports
(see table 8 for port pin-out listing) via a cable terminated with RJ-45 plugs. A cross-over cable is only required
when connecting SmartNode 4110 Series devices to a host (see
Note
Pins not listed are not used.
38
Table 8. Ethernet 10/100Base-T (RJ-45) port pin-outs
Pin
1
2
3
6
Figure 17. Connecting to a hub
Model 4520 & 4110 Series Getting Started Guide
figure 18 on page 39).
Signal
TX+
TX-
RX+
RX-
Installing the gateway router